Ozzle print how to#
I think its useful, because these were issues I ran into and it was not always obvious how to fix them. But only if you consider it useful enough for people. Maybe you can add a section "Notes" after the section "Installation". I think the following needs to be added to the README.md. PS Maybe I just overlooked some builtin features of slic3r or this firmware distribution, and I'm doing things in a more complicated way than I have to? Nevertheless, maybe this can save people some time. G1 X100 Y100 F3000 move to front right corner Safely position nozzle to start printing M116 Wait until target temperatures for extruder and heated bed are reached For me, it prevents the printhead from hitting screws, speeds up heating and homing by doing it all at once and it performs a cleanup by moving the nozzle over the cleaning brush (for lack of a better word). (when slicing I put the g-code int the slic3r g-code field). printer does not perform the printhead cleanup operation after heating the nozzle.
After this, it would start homing the z-axis, instead of doing all three at once. printer would first heat the nozzle, after this was completed it would start heating the bed.printhead was hitting the print bed screw at the start of the print.z axis was too high (I had to set a negative z-offset in slic3r of -3.4mm).Unless the issues I was having were specific to me. Since it took quite a lot of time, I think It could be added to the documentation. However, I had to spent some time to get the start and end g-code right. First of all, thanks for all the work, the firmware has been working great and I have been using it for about a year now.
0 kommentar(er)
